Difference between revisions of "Sprite port-mirror Index Register"

From SpecNext official Wiki
Jump to: navigation, search
m
m (4 revisions imported)
(No difference)

Revision as of 10:00, 14 April 2019

Number $34
Readable Yes
Writable Yes
Short Description Selects sprite index 0..127 to be affected by writes to other Sprite ports (and mirrors).


If sprite id lockstep in Peripheral 4 Register ($09) is enabled, write to this registers has same effect as writing to Sprite Status/Slot Select ($303B / 12347).

I.e. bit 7 offsets pattern writes by 128 bytes (second half of 0..63 pattern slot), and bits 6-0 contain index 0..63 (for patterns) or 0..127 for sprite attributes, resetting those indices for ports Sprite Attribute Upload ($xx57 / 87) and Sprite Pattern Upload ($xx5B / 91) and for following NextRegs $35..$39 and $75..$79.

Index-increments caused by write to NextRegs $75..$79 will propagate also to current index of port $xx57 and reset current attribute (next write to port $xx57 after index change will modify first byte of attributes).

The index increment caused by sending full attribute set to port $xx57, or by writing to port $303B, will also propagate to this register, affecting next writes to registers $35..$39/$75..$79.


If sprite id lockstep in Peripheral 4 Register ($09) is disabled, bit 7 is ignored and bits 6-0 value selects index 0..127 for NextRegs $35..$39 and $75..$79 (decoupled from ports $xx57/$303B completely).


Bit 7 always reads back as zero.