Search results

Jump to: navigation, search
  • ...om the root of the SD card. If this fails, an error message is displayed ("Error initializing SD card!"), the border turns red, and the code loops.
    2 KB (341 words) - 16:09, 4 April 2020
  • | CONTINUE || Repeats last command or restarts from error location | 0x8f || ERROR
    14 KB (2,561 words) - 11:06, 26 July 2022
  • | N1 || $5B5E || RAMERR || Error number passed from ROM 1 to ROM 3. Also used by SAVE/LOAD as temporary driv | X2 || $5C3D || ERRSP || Address of item on machine stack to be used as error return.
    10 KB (1,519 words) - 15:39, 26 April 2019
  • :bit 6 = 1 if the Rx experienced a framing error ; (clears on read, includes parity and stop bit errors) :bit 5 = 1 if the next Rx byte was received after an error condition was detected (framing, overflow)
    801 bytes (128 words) - 22:05, 1 July 2022
  • : Inline help, line number completion and inline error checking
    4 KB (632 words) - 04:46, 8 September 2020
  • If you use these without a RTC soldered to the board they will just give an error that no signature is found or No ACK received. You can however use the opti
    2 KB (424 words) - 10:54, 12 October 2021
  • First of all when you press ''ENTER'' you should get 'ERROR' because you didn't send a valid command to the ESP module. If you don't th ...IFT+9) you can cycle through each option pressing ''ENTER'' until you see "ERROR!" (If you can physically see the module then many have a little blue light
    10 KB (1,758 words) - 14:19, 20 February 2022
  • ...d save it to file “knight.bin”. If “knight.bin” already exists, an error will be produced (see -f).
    3 KB (511 words) - 22:36, 31 May 2020
  • TBBLUE.30104.P512.V2.TBU passed but had an error in the joystick logic. * '''PASS 3.01.04 TBBLUE.30104.P512.V2.TBU (ERROR IN JOYSTICK LOGIC)'''
    47 KB (3,301 words) - 22:28, 4 August 2020