Circuit Diagrams
From SpecNext official Wiki
Contents
- 1 Schematics
- 2 J13 - Daughter board connector - Issue 2A/2B
- 3 J13 - Daughter board connector - Issue 4
- 4 J15 - Next GPIO
- 5 CN5 - Expansion bus (edge connector)
- 6 J10/J11 - Memory Expansion Ports
- 7 J4/J7 J8/J14 - Joystick Ports
- 8 CN1 - VGA Video Port
- 9 CN8 - Digital Port
- 10 CN2/CN6/CN7 - SD Reader (Mainboard) (CN6 on reverse)
- 11 CN10/CN11/CN12 - SD Reader (Daughterboard) (CN12 on reverse)
- 12 Accelerator Board
- 13 Real Time Clock (RTC)
- 14 CN9 - ESP8266-01/RS-232 Port
Schematics
The KS1 and KS2 schematics can be downloaded here.
The three tail matrix keyboard schematic can be downloaded here.
J13 - Daughter board connector - Issue 2A/2B
|
|
J13 - Daughter board connector - Issue 4
|
|
J15 - Next GPIO
|
|
CN5 - Expansion bus (edge connector)
|
|
J10/J11 - Memory Expansion Ports
|
|
J4/J7 J8/J14 - Joystick Ports
|
|
CN1 - VGA Video Port
|
|
Notes:
- In VGA mode (scandoubler enabled), H-SYNC and V-SYNC are carried separately on their respective pins.
- In RGB mode (scandoubler disabled), H-SYNC carries composite sync, and V-SYNC carries 1.
- Pin 14 carries 3V3, which can be connected to SCART pin 16 to indicate RGB to the display.
- There is no convenient source of voltages between 9.5-12V to indicate 4:3 aspect ratio to the display on SCART pin 8, so this is usually left unconnected.
CN8 - Digital Port
|
|
CN2/CN6/CN7 - SD Reader (Mainboard) (CN6 on reverse)
|
|
CN10/CN11/CN12 - SD Reader (Daughterboard) (CN12 on reverse)
|
|
Accelerator Board
|
|
Real Time Clock (RTC)
|
|
CN9 - ESP8266-01/RS-232 Port
|
|