Internal Port Decoding b24-31 Register
From SpecNext official Wiki
| Number | $85 |
|---|---|
| Readable | Yes |
| Writable | Yes |
| Short Description | Enabling internal ports decoding |
| Bit | Description |
|---|---|
| 7 | (bit 31) (since core3.1.1) re-init all bits 0-31 to 1 upon:
0: hard reset
|
| 6-2 | (bit 30-26) Reserved, preserve the current value (or at least use 1) |
| 1 | (bit 25) Enabling MB02 DMA Port ($xx0B / 11) (since core3.1.2) |
| 0 | (bit 24) Enabling ($BF3B) and ($FF3B) (ULA+) |
since core3.1.1: all bits are set to 1 when: soft reset and bit 31 is set OR hard reset and bit 31 is clear (otherwise content is kept intact). All bits are set to 1 upon soft reset.
The internal port decoding enables always apply.
When the expansion bus is on, the expansion port decoding (Next Registers $86-$89) enables are logically ANDed with the internal enables (Next Registers $82-$85). A zero bit indicates the internal device is disabled.
If the expansion bus is on, this allows I/O cycles for disabled internal ports to propagate to the expansion bus, otherwise corresponding I/O cycles to the expansion bus are filtered.
(note: Next registers with number higher than $7F are inaccessible from Copper code)