UART Frame: Difference between revisions
From SpecNext Wiki
Created page with "{{Port |Number=$163B |NumberDec=5691 |PortMask=%0001 0110 0011 1011 |ShortDesc=UART Frame |Readable=Yes |Writable=Yes |Subsystem=UART }} 0x163B UART Frame (R/W) (hard reset =..." |
m formatting of description |
||
| Line 8: | Line 8: | ||
|Subsystem=UART | |Subsystem=UART | ||
}} | }} | ||
0x163B UART Frame | 0x163B UART Frame (R/W) (hard reset = 0x18) | ||
(R/W) (hard reset = 0x18) | bit 7 = 1 to immediately reset the Tx and Rx modules to idle and empty fifos | ||
bit 7 = 1 to immediately reset the Tx and Rx modules to idle and empty fifos | bit 6 = 1 to assert break on Tx (Tx = 0) when Tx reaches idle | ||
bit 6 = 1 to assert break on Tx (Tx = 0) when Tx reaches idle | bit 5 = 1 to enable hardware flow control * | ||
bit 5 = 1 to enable hardware flow control * | bits 4:3 = number of bits in a frame | ||
bits 4:3 = number of bits in a frame | 11 = 8 bits | ||
10 = 7 bits | |||
01 = 6 bits | |||
00 = 5 bits | |||
bit 2 = 1 to enable parity check | |||
bit 2 = 1 to enable parity check | bit 1 = 0 for even parity, 1 for odd parity | ||
bit 1 = 0 for even parity, 1 for odd parity | bit 0 = 0 for one stop bit, 1 for two stop bits | ||
bit 0 = 0 for one stop bit, 1 for two stop bits | : * The esp ignores hardware flow control | ||
* The esp ignores hardware flow control | : * In joystick i/o mode only cts is available | ||
* In joystick i/o mode only cts is available | |||
Revision as of 04:07, 2 July 2022
| Number | PortNumber::$163B |
|---|---|
| Decimal | NumberDec::5691 |
| Short desc. | ShortDesc::UART Frame |
| Bit Mask | [[PortMask::%0001 0110 0011 1011]] |
| Readable | Readable::Yes |
| Writable | Writable::Yes |
| Subsystem | Subsystem::UART |
0x163B UART Frame (R/W) (hard reset = 0x18) bit 7 = 1 to immediately reset the Tx and Rx modules to idle and empty fifos bit 6 = 1 to assert break on Tx (Tx = 0) when Tx reaches idle bit 5 = 1 to enable hardware flow control * bits 4:3 = number of bits in a frame 11 = 8 bits 10 = 7 bits 01 = 6 bits 00 = 5 bits bit 2 = 1 to enable parity check bit 1 = 0 for even parity, 1 for odd parity bit 0 = 0 for one stop bit, 1 for two stop bits
- * The esp ignores hardware flow control
- * In joystick i/o mode only cts is available