From SpecNext official Wiki
|
(Tag: Redirect target changed) |
| (19 intermediate revisions by 3 users not shown) |
| Line 1: |
Line 1: |
| − | The Spectrum Next is known to have an header (with male pins) which can attach a Raspberry Pi Zero.
| + | #REDIRECT [[Pi:Main_Page]] |
| − | | |
| − | The Raspberry Pi 0 has a Broadcom BCM2835 SoC with an ARMv6 core, a Videocore 4 GPU, and its own 512 MB memory and HDMI output. It has its own SD card from which it boots. While it can traditionally run Linux, it can also be programmed "bare metal" directly in assembly language, which may be more likely for this implementation.
| |
| − | | |
| − | It is not yet known how the Raspberry Pi 0 will interface with the Spectrum Next. It was originally used as an HDMI converter, but the HDMI functionality was moved onto the main board, makes this unnecessary.
| |
| − | | |
| − | It is known that the Raspberry Pi versions supporting Wifi will not provide that Wifi to the Next.
| |
| − | | |
| − | | |
| − | == Attaching a Raspberry Pi Zero ==
| |
| − | | |
| − | To connect the RPi0 to the Spectrum Next, a 20x2 pin female header needs to be attached on the underside of the Pi:
| |
| − | | |
| − | <gallery widths=200px>
| |
| − | RPi0_2x20pinFemale.png|Header attached using solder
| |
| − | RPi0_2x20pinFemale_Hammer.png|Solder-less variety attached using a hammer
| |
| − | RPi0_1.jpg|Raspberry Pi Zero connected to the Spectrum Next
| |
| − | </gallery>
| |
Latest revision as of 13:36, 2 February 2020
