Circuit Diagrams: Difference between revisions
From SpecNext Wiki
No edit summary |
No edit summary |
||
| Line 35: | Line 35: | ||
{| width=100% | {| width=100% | ||
|valign=top width= | |valign=top width=30%| [[Image:J15-I4-GPIOLocation.png]] | ||
|valign=top| [[Image:J15-I4-CircuitGPIO.png]] | |valign=top| [[Image:J15-I4-CircuitGPIO.png]] | ||
|} | |} | ||
Revision as of 11:03, 10 December 2023
Schematics
The KS1 and KS2 schematics can be downloaded here.
The three tail matrix keyboard schematic can be downloaded here.
J13 - Daughter board connector - Issue 2A/2B
|
|
J13 - Daughter board connector - Issue 4
|
|
J15 - Next GPIO - Issue 2A/2B
|
|
J15 - Next GPIO - Issue 4
|
|
CN5 - Expansion bus (edge connector)
|
|
J10/J11 - Memory Expansion Ports
|
|
J4/J7 J8/J14 - Joystick Ports
|
|
CN1 - VGA Video Port
|
|
Notes:
- In VGA mode (scandoubler enabled), H-SYNC and V-SYNC are carried separately on their respective pins.
- In RGB mode (scandoubler disabled), H-SYNC carries composite sync, and V-SYNC carries 1.
- Pin 14 carries 3V3, which can be connected to SCART pin 16 to indicate RGB to the display.
- There is no convenient source of voltages between 9.5-12V to indicate 4:3 aspect ratio to the display on SCART pin 8, so this is usually left unconnected.
CN8 - Digital Port
|
|
CN2/CN6/CN7 - SD Reader (Mainboard) (CN6 on reverse)
|
|
CN10/CN11/CN12 - SD Reader (Daughterboard) (CN12 on reverse)
|
|
Accelerator Board
|
|
Real Time Clock (RTC)
|
|
CN9 - ESP8266-01/RS-232 Port
|
|