Sprite and Layers System Register

Number	TBRegisterNumber::$15
Readable	TBRegisterReadable::Yes
Writable	TBRegisterWritable::Yes
Short Description	[[ShortDesc::Enables/disables Sprites and Lores Layer, and chooses priority of sprites and Layer 2.]]

Bitmapped as follows:

Bit	Function
7	Enable Lores Layer
6	If 1, the sprite rendering priority is flipped, i.e. sprite 0 is on top of other sprites (0 after reset)
5	If 1, the clipping works even in "over border" mode (doubling X-axis coordinates of clip window) (0 after reset)
4-2	Layers priority and mixing
1	Enable sprites over border (0 after reset)
0	Enable sprite visibility (0 after reset)

Bits 4-2	Priority and mixing of layers
%000	S L U (Sprites are at top, Layer 2 under, Enhanced_ULA at bottom)
%001	L S U
%010	S U L
%011	L U S
%100	U S L
%101	U L S
%110	since core3.1.1: (U|T)S(T|U)(B+L) Blending layer and Layer 2 combined, colours clamped to [0,7] S (U+L) Colours from ULA and Layer 2 are added (per R/G/B channel) and clamped to 7.
%111	since core3.1.1: (U|T)S(T|U)(B+L-5) Blending layer and Layer 2 combined, colours clamped to [0,7] S (U+L-5) Similar as previous, but per R/G/B channel (U+L-5) is calculated and result is clamped by 0..7 range.

In layer mixing modes (%110 and %111) the "priority bit 7" of Layer 2 colour is propagated through the calculation, i.e. such pixel will raise above sprites even in mixing modes. If either U|T or L layer contains transparent colour pixel, the other layer pixel is drawn unchanged (skipping mixing calculation).

Since core3.1.1 the blending modes allow for layer non-contributing-to-blending (use {{#ask: TBRegisterNumber::$68 }} ($68) to configure blending sub-mode) to show independently in front of sprites.

When both "over border" (bit 1) and "clipping over border" (bit 5) is enabled, the Sprite clipping window {{#ask: TBRegisterNumber::$19 }} ($19) X-axis coordinates are "doubled", and coordinates origin is moved from pixel [0,0] position to sprite [0,0] position ([-32,-32] pixel position). For example: setting clip coordinates as {x1:5, x2:155, y1:7, y2:248} will make sprites visible in area [10,7]..[311,248] (inclusively) in sprite coordinates, i.e. the first visible pixel is at X1*2 coordinate, and last visible pixel is at X2*2+1 coordinate.