Interrupt Enable 2
From SpecNext official Wiki
| Number | $C6 |
|---|---|
| Readable | Yes |
| Writable | Yes |
| Short Description | UART interrupt enable control |
bit 7 = Reserved must be zero bit 6 = UART1 Tx empty bit 5 = UART1 Rx near full \ shared bit 4 = UART1 Rx available / interrupt bit 3 = Reserved must be zero bit 2 = UART0 Tx empty bit 1 = UART0 Rx near full \ shared bit 0 = UART0 Rx available / interrupt
- Rx near full overrides Rx available
- If a device interrupt is disabled, it enters a polled mode
Soft reset = 0x00